Community Profile

Last seen: 11 månader ago Active since 2021

#### Content Feed

View by

Question

replace the repeated number in a given sequence with value of zero
Dear Sir/Madam, I want to replace the value of Z2,Z4,Z6,Z7,Z9,Z10,Z12,Z13... and so on with value of zero. I have attached the...

### 1

Question

to form a helix spiral
Dear all I am unable to for a helix spiral using attached code. First i want to mirror the generated curve in opposite directi...

ungefär ett år ago | 1 answer | 0

### 1

Question

Repetetion of x,z,b,c value simulataneous
Dear sir/madam, I am unable to repeat the x,z,c,b value simultaneously. I have attached the final plot to be obtained. Ple...

ungefär ett år ago | 1 answer | 0

### 1

Question

plot is showing blank
I am not able to generate the plot. It is showing empty. Please help me to solve the same Thank you clear all clc %% calcul...

ungefär ett år ago | 3 answers | 0

### 3

Question

not able to solve the integration function
Dear Sir/Madam, I am not able to solve the given integration function. The screenshot of given is attached and the code is give...

ungefär ett år ago | 2 answers | 0

### 2

Question

optimization of n for dual blaze wavelength
This code has two optimization value along with two weight i.e. [1541;3160;0.5;0.5] everytime i run the code i recieved the m...

ungefär ett år ago | 0 answers | 0

### 0

Question

curve generation plot for given pdf
I am not able to generate the curve of FIg.5 as per attached pdf or given link below file:///C:/Users/kp/OneDrive/Desktop/yang2...

ungefär ett år ago | 0 answers | 0

### 0

Question

optimization value not able to acheive
I am not able to get the optimize value of n. Every time it shows Failure in initial objective function evaluation. FSOLVE canno...

ungefär ett år ago | 2 answers | 0

### 2

Question

I want to add number in given sequention
I want to add 0.5 to x2, x5, x8, x11 and so on, without altering the value of x1, x3, x4, x6, x7, x9, x10. How to write code ...

ungefär ett år ago | 2 answers | 0

### 2

Question

Error in figure (2)
R=10; %% radius of workpiece f=0.5; %% feed rate in mm/min s=50; %% spindle speed in rpm N=100; %% no of points in one r...

mer än ett år ago | 0 answers | 0

### 0

Z must be a matrix, not a scalar or vector
R=10; f=0.5; s=50; N=100; a=f/(s*N); Ax=2; Ay=2; lx=2.5; ly=2.5; n=((R*s*N)/f)+1; r(0)=0; Z(0)=0; t=0.5; for i=1:n ...

mer än ett år ago | 0

Question

Z must be a matrix, not a scalar or vector
clc clear all R=10; f=0.5; s=50; N=36; a=f/(s*N); Ax=0.002; Ay=0.002; lx=2.5; ly=2.5; n=((R*s*N)/f)+1; for i=1:n r(...

mer än ett år ago | 2 answers | 0