Statistics
RANK
165 776
of 299 784
REPUTATION
0
CONTRIBUTIONS
6 Questions
2 Answers
ANSWER ACCEPTANCE
66.67%
VOTES RECEIVED
0
RANK
of 20 803
REPUTATION
N/A
AVERAGE RATING
0.00
CONTRIBUTIONS
0 Files
DOWNLOADS
0
ALL TIME DOWNLOADS
0
RANK
of 165 909
CONTRIBUTIONS
0 Problems
0 Solutions
SCORE
0
NUMBER OF BADGES
0
CONTRIBUTIONS
0 Posts
CONTRIBUTIONS
0 Public Channels
AVERAGE RATING
CONTRIBUTIONS
0 Highlights
AVERAGE NO. OF LIKES
Feeds
Question
Problems getting Master Transfer Block to function
I would welcome a pointer to some clearer documentation for the c28x SPI Master Transfer block in provided for TI MCU for use in...
nästan 3 år ago | 1 answer | 0
1
answerQuestion
SPI interface timing with deasserts
I'm looking for a way to read data from a Si8380S-IU chip from a TI F2337xD based processor. The Simulink examples for Master T...
nästan 3 år ago | 0 answers | 0
0
answersQuestion
Problem with external mode and model running on target hardware
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for mod...
nästan 3 år ago | 1 answer | 0
1
answerHow to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
nästan 3 år ago | 0
Question
Errors when examining CAN log output in Mathworks
I'm getting an error "Reference to non-existent field 'x_440V_Tripped' when attempting to load a CAN log file from a simulation ...
nästan 3 år ago | 1 answer | 0
1
answerQuestion
Ordering of CAN signal ports, when CAN Pack/Unpack is using "CANdb specified signals"
Regardless of the order in the CANdb file or the bit order assigned to signals, CAN unpack will show its outputs in alphabetical...
nästan 3 år ago | 1 answer | 0
1
answerUnclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
ungefär 3 år ago | 0
| accepted
Question
Unclear error message for Swicth-Case Action on model update
The error message "The action port on subsystem '......../Chip1_WriteBytes1' can only be connected to an If or Switch-Case and m...
ungefär 3 år ago | 1 answer | 0
