How to solve the 'StopFcn' error when the cause is "Vectors must be the same length."
38 views (last 30 days)
Show older comments
I have got a simulation file for a grid-tie inverter, which I am going to leave its image below. When I run the simulation, I receive the following error:
Error evaluating 'StopFcn' callback of block_diagram 'DC2ACGRID2'.
Caused by:
Vectors must be the same length.
I cannot figure out what vectors are causing this trouble. Any help is very much appreciated.
16 Comments
Walter Roberson
on 13 May 2021
set_param('YourModelNameGoesHere', 'StopFcn', '')
then save your model.
Lazar Dulovic
on 30 Jun 2022
Answers (1)
Scout Patel
on 31 Mar 2021
- Go to the "MODELING" tab on the simulink window.
- In the Center click on "Model Settings".
- Under Data Import/Export UNCHECK the box next to: "Single Simulation output:"
2 Comments
See Also
Categories
Find more on Programmatic Model Editing in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!