need name of the block in simscape tools

Good day

In this scheme can pplease tell me what is or what is the name of block which one is connected from Motor output to the second input of the scope block?

best regards

Answer 1

[Sam Chak]

Hi @Hamid Ullah

It appears to be a Simscape block diagram. Simscape components cannot be connected directly to the Scope block. To measure the output of the motor, you would need to use a Motion Sensor and convert the physical state (PS) signal into a Simulink signal. This conversion is necessary in order to display it in the Scope.

The w block is a Masked Subsystem block.

[Sam Chak]

You're welcome, @Hamid Ullah. However, please note that I manually constructed the block configuration shown in the image using three components:

• Ideal Rotational Motion Sensor
• Mechanical Rotational Reference
• PS-Simulink Converter

I did not refer to the actual Simulink example of "Closed-loop pump control with Flexible Drive Shaft" when creating the masked subsystem. If you would like to view the example as suggested in the provided link, you can use the following command:

openExample('simscapefluids/ClosedLoopPumpControlWithFlexibleDriveShaftExample')