photo

Sisi Di


NUAA

Active since 2016

Followers: 0   Following: 0

Message

Statistics

  • Thankful Level 1

View badges

Feeds

View by

Question


How does the sine wave block in Simulink work?
I put two sine wave blocks in my Simulink model,whose parameters were both set like this. <</matlabcentral/answers/uploaded_f...

mer än 7 år ago | 0 answers | 0

0

answers

Question


What do TzL & TzR mean in Simulink Debugger ?
When I debugged my model in the Simulink debugger, I came across such information.I don't know what are Tzl and TzR short for, w...

mer än 7 år ago | 1 answer | 0

1

answer

Question


Why can't I build model in Simulink which contains a S-function?
I'm learning the S-function with the examples in the Matlab, but I failed to build model of the examples. What is confused is th...

mer än 7 år ago | 1 answer | 0

1

answer

Question


How to set the initial value for iteration in Simulink?
I'm building a model in Simulink on iteration algorithm, but I failed to set the inital value for my parameters. I used a 'Matla...

nästan 8 år ago | 2 answers | 0

2

answers

Question


What does "File I/O error on file 'rti1104.tlc' " mean?
I'm making a controller with Simulink. However,when it comes to the build up, "File I/O error on file 'rti1104.tlc';"Operation t...

nästan 8 år ago | 2 answers | 0

2

answers

Question


confused of the simulink configuration
When I use Simulink, I always get the wrong results not beacuse of the model, but the setting in the configuration parameters. I...

nästan 8 år ago | 0 answers | 0

0

answers

Question


how can I generate a high frequency signal with simulink
I'm trying to generate a 40kHz sine wave with signal generator in simulink, but the result in the scope looks like a triangle wa...

nästan 8 år ago | 1 answer | 0

1

answer

Question


How to identify the system model with input data measured at varying sample time?
I measured the rotate speed of my motor using T method, which helps me get the results by recording the interval between adjacen...

ungefär 8 år ago | 0 answers | 0

0

answers

Question


How does FFT work with limited data?
I've collected 2000 pairs of data at the frequency of 200Hz. I hope to figure out the noise at about 50kH, since my motor works ...

ungefär 8 år ago | 1 answer | 0

1

answer