photo

REVU VARAPRASAD


Active since 2015

Followers: 0   Following: 0

Statistics

  • Thankful Level 1

View badges

Feeds

View by

Question


how i can split DVB_T signal into matrix form which is 256 by 256 in simulink.which block it will support.
I am doing project in simulink on spectrum sensing in cognitive radio.I am facing problem. I taken DVBT i/p signal. I want mult...

mer än 8 år ago | 0 answers | 0

0

answers

Question


i want to create M-Block for histogram in system generator for 1000 samples.i am loading following code but i am getting syntax error at line 3. please guide me to design a M-Block for histogram
function z1 = xlmax(z) load ('newfile.txt'); a=newfile(:,1); z=xlmax(a) figure(1) %plot(z) sum(z) figure(...

mer än 8 år ago | 2 answers | 0

2

answers

Question


I want to design xilinx histogram block for MATLAB 7.4.0(R2007) in system generator .I wrote M-Code and simulating but i am geting error at line 2 of following program.Please any one help me to create M-Block for histogram.
function pr = srinu(a) load newfile.txt; a=newfile(:,1); z=xlmax1(a); % figure(1) %plot(z) sum(z) figure(...

mer än 8 år ago | 1 answer | 0

1

answer

Question


Is there any block in simulink to read complex matrix from matlab workspace to simulink design.
how to read 256 by 256 complex matrix from workspace into simulink design.Which block i can use to read this complex matrix from...

mer än 8 år ago | 0 answers | 0

0

answers

Question


I want read 256 by 256 complex matrix from workspace to simulink model in SysGen.which block it support.please guide me.
how to read 256 by 256 complex matrix from workspace into simulink design.Which block i can use to read this complex matrix from...

mer än 8 år ago | 1 answer | 0

1

answer

Question


while run the following matlab program i am geting error as Index exceeds matrix dimensions.please tell me where i did wrong.
a=[9 4 9 3 9 1 9 0] binsize=9/10; if (n<10) for n=0:10 count=0 for i=0:10 if cond(n*bins...

nästan 9 år ago | 1 answer | 0

1

answer

Question


I want's to create M-Block for histogram in a system generator(simulink).For that I want to write a matlab program for histogram without using hist function.how i will proceed.
Xw = abs(fft(Xt)); ki = hist(Xw,L) Here L=10 and Xw=Columns 1 through 9 2.6745 0.8621 0.4602 0.9763 ...

nästan 9 år ago | 0 answers | 0

0

answers

Question


How to write matlab program for histogram with out using hist function.
Xw = abs(fft(Xt)); ki = hist(Xw,L)%%% L=bin lenth,Xw=1000 randam samples

nästan 9 år ago | 4 answers | 0

4

answers