How to correct this error for simulating this changed IEEE 14 bus.
2 views (last 30 days)
Show older comments
Sangho Park
on 19 Nov 2020
Answered: Joel Van Sickel
on 19 Nov 2020
Good day sir!
Now I am struggling to IEEE 14 bus simulation. In order to change the block of 'Generator1' into the 'Generator2' that has a input parameter(frequency).
I am the Newbie of this simulink, so I downloaded two files that, 'Fourteen_bus' and 'wNAPS'. (These are well made one, and very helpful to me.=> file attacked)
I copied generator from 'wNAPS' and pasted to 'Fourteen_bus' and replace one of generators in 'Fourteen_bus'.
But one error occured. even though I adjusted many parameters.....
Would you please give some instruction to overcome this?
wNAPS as follow.
Fourteen_bus as follow
And I try to...
Like this...(replace generator)
And error as follow....
What should I do..?
I attaqched two files as below.
0 Comments
Accepted Answer
Joel Van Sickel
on 19 Nov 2020
Hello Sango,
please start by following the recomendations in the error message. In this case, addiding snubber resistors (make them high value) from the problematic node to ground. You cannot connect 2 current sources in series without an alternet path for current to flow. You want to size the resistor to draw 1 percent of total current or less if possible. The smaller the resistor, the higher the current draw, which effects the simulation more, but will allow the simulation to converge with a larger time step, aka run faster.
Regards,
Joel
0 Comments
More Answers (0)
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!