lookup table error in simulink

44 views (last 30 days)
vishnuvardhan naidu tanga
vishnuvardhan naidu tanga on 29 May 2020
Commented: Sai Sri Pathuri on 2 Jun 2020
Hello I am trying to model a 2D lookup table in simulink. I am calling the break points and table data from workspace. When i run it it shows an error as "the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2)." but when I check the table dimensions are table data: 1x9000 and break point 1 : 1x9000 and break point 2: 1x9000 all are same. But still I am getting this error. Please guide me through it.

Answers (1)

Sai Sri Pathuri
Sai Sri Pathuri on 2 Jun 2020
Check whether you have set Number of table dimesions to 1, since your data is one-dimensional
  4 Comments
vishnuvardhan naidu tanga
yes i run the code. when i run the code the break points are updated from the data base. the error marks in break points are eliminated. But the system wont run because of the following error:
In block 'SH', the number of dimensions specified by the 'Table data' parameter (1) must match the 'Number of table dimensions' parameter value (2).
Sai Sri Pathuri
Sai Sri Pathuri on 2 Jun 2020
Set Number of table dimensions (I highlighted it in above screenshot) to 1 in the dialog box, because your input is one-dimensional

Sign in to comment.

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!