filling an empty matrix using a for loop

for j = abs(1:20:size(Bz,1))
    Yi = Bz(j,minK(1,1));
    lateral = find_coordinate(R2,Z2,Bz,Yi,0);
    M_tot_spions_z = langevinfunc2(n,Kb,T,Brex(j,minK(1,1)), f, Vc, Ms,N);
    U_det_r = abs((Yi.*M_tot_spions_z)/100e-9);  % Counts 100[nV] Induced voltage [V]
    
    figure;
    plot(T_comb,U_det_r)
    title([' Detected signal @ lateral distance =', num2str(abs(lateral)),' [m]'])
    xlabel('Time [s]')
    ylabel('Voltage [V]')
    hold on
    plot(T_comb, Noise)

end

Hello,

Is there a possibity to save all values for U_det_r so I can use these later on in a different plot?

Answer 1

[Srivardhan Gadila]

You can define U_det_r as a cell array or normal array and store the values corresponding to each iteration as follows:

U_det_r = {};
for j = abs(1:20:size(Bz,1))
    Yi = Bz(j,minK(1,1));
    lateral = find_coordinate(R2,Z2,Bz,Yi,0);
    M_tot_spions_z = langevinfunc2(n,Kb,T,Brex(j,minK(1,1)), f, Vc, Ms,N);
    U_det_r{j} = abs((Yi.*M_tot_spions_z)/100e-9);  % Counts 100[nV] Induced voltage [V]
    
    figure;
    plot(T_comb,U_det_r{j})
    title([' Detected signal @ lateral distance =', num2str(abs(lateral)),' [m]'])
    xlabel('Time [s]')
    ylabel('Voltage [V]')
    hold on
    plot(T_comb, Noise)
end

Refer to cell array & Matrices and Arrays documentation for more information.