How to model tapped windings in Simscape?
3 views (last 30 days)
Show older comments
Hello,
I want to model a multi output flyback transformer with tapped at secondary windings. Therefore there will be two output of the transformer according to number of turns above and below the tap.
So far I have used a model as attached and also I a attached the configuration i want in reality.
I would like to know do the model and the reality match each other?
Any help will be highly appreciated.
Thanks
0 Comments
Answers (2)
Nikhil Sonavane
on 30 Jan 2020
You can refer to the documentation of Multi-Winding Transformer block which gives a detailed explanation about tapped transformer windings. You can adjust the number of of this block by double clicking on it adjusting the number of taps as required. You can also refer to the screenshot which I have attached.
3 Comments
Adithya C
on 15 Feb 2023
You can use Mutual Inductor block in the MATLAB physical model system.
0 Comments
Communities
More Answers in the Power Electronics Control
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!