Finding a Signal from an noisy signal
2 views (last 30 days)
Show older comments
Rohan Mehta
on 2 Sep 2019
Commented: Image Analyst
on 3 Sep 2019
I am having an signal as displayed in the image the red signal is the input and the blue one is outut as we can see that we have six peaks obtained in the input (Red) signal and the same should be present in the output (Blue) signal. I want to find the the signals in the blue samples. Is there any kind of filter or code which I can apply to find the signals.
Please note that signals attached in the image are created using an CSV file which contains the amplitudes of the signals.
0 Comments
Accepted Answer
Image Analyst
on 2 Sep 2019
Simply use masking:
mask = redSignal > 0.1; % Logical index (mask) of where the red signal is higher than 0.1.
% Now replace those bad red signal locations with the good blue signal:
redSignal(mask) = blueSignal(mask);
2 Comments
Image Analyst
on 3 Sep 2019
Not sure what additional I can say. The green comment above say it all. The mask is where the red signal is higher than 0.1 (bad signal locations/indexes). And then I replace those bad red signal locations with the values from the good blue signal. Read it again and tell me where you see some ambiguity or uncertainty in what it says.
More Answers (0)
See Also
Categories
Find more on Author Block Masks in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!