How to connect RC controller physically to computer to use Radio Control Transmitter Block in Simulink?

How do you connect physically an RC receiver to your computer for simulation using the Radio Control Transmitter Block (from Embeded Coder Support Package for PX4 Autopilots Library) in Simulink?

Answer 1

[Daniel_]

Hello Kent. If I understand well what you want to do, you need hardware - some sort of autopilot supported by Pixhawk Pilot Support Package (for example Pixhawk Cube). Then you connect the rc receiver to the autopilot, and the autopilot communicates (for example via USB) with Matlab / Simulink installed on computer. A hardware prepared in this way allows you to read and use in Matlab / Simulink the signals sent from the rc transmitter to the rc receiver.

[yusuf amran]

yes we need the answer, so how to figure out the problem, i have done sync the simulink with px4 and connect the rc remote with the jmavlinka and qgroundcontrol, but rc remote did not connecting with the simulink.