The error using "load" and "fgets" codes in MATLAB 2013a?
1 view (last 30 days)
Show older comments
I just want to use "load" command and "fgets" command in same time.
fid is a txt file which contains the directories of 40 seperate file.
fid=
materialproperties/uniaxialelement1.txt
materialproperties/uniaxialelement2.txt
materialproperties/uniaxialelement3.txt
....
....
....
So i use fgets(fid) to get the directory of any file as
fgets(fid)= materialproperties/uniaxialelement2.txt
then I need the data of this file so i use" load" command
Read_Pr=load(fgets(fid))
this code work efficently in MATLAB 2014a but i have to run the code in MATLAB 2013a but i get an error.
So what can i do for running this code without any errors in MATLAB2013a?
Whats is difference in using "load" code?
4 Comments
Stephen23
on 29 Dec 2018
Edited: Stephen23
on 29 Dec 2018
@ugur ugur: the error message gives the filename that you are trying to use, and you can clearly see that it includes a newline at the end:
... 'materialproperties/uniaxialelement2.txt
'
This is exacty as I already described in my answer, together with the solution. If you used my answer then there would be no newline character at the end.
PS: I doubt that the error message actually says "Enable to read file".
PPS: remember to accept my answer (it answers your question) and also answers to your other questions:
Accepted Answer
More Answers (0)
See Also
Categories
Find more on Whos in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!