Using simDriveline model, no lost ( efficiency 100%) in my driveline model, why the power is reduced
3 views (last 30 days)
Show older comments
I am developing a simple driveline model using simDriveline. We know if there is no efficiency lost and no gear ratio change on the driveline ( efficiency = 100%, gear ratio = 1), so we can get always the same power at each positions on driveline, because efficient = 100%.
In my model, there are two points A and B, in both positions Rotation and torque are same measured with simscape sensor(reasonable! because over all efficient = 100%, over all gearbox ratio = 1). But if I add a Inertia component on B position ( always with no lost), the torque value in B position will be reduced but rotation keept same. Now the Power ( Power = rotaton * torque) in position B is smaller than Power in position A. I can not understand ,there is no lost ( efficiency = 100%) in my driveline model, why the power is reduced from A to B? where i lost the power?
please help me! thanks a lot.
xiaoming
0 Comments
Answers (1)
Steve Miller
on 6 Dec 2022
Without your model, it is hard to be sure what the error is. I suspect you haven't properly sensed and calculated the power in all locations. If you increase the inertia but do not increase the input torque, the output speed will reduce.
--Steve
0 Comments
See Also
Categories
Find more on Sensors in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!