How to combine multiple surfaces and extract data points (faces and vertices ) as one surface?
14 views (last 30 days)
Show older comments
I have 5 surfaces in one file as a (5x1 struct with 2 fields) format, as attached. each one is made of Points(vertices) and ConnectivityList (faces). I was able to trisurf them using for loop as shown in my code. What I want is to combine them as one surface(1x1 struct with 2 fields) which has only one field of Points and only one field of ConnectivityList. so I can trisurf it and deal with it as on surface without for loop.
Thank you so much
SurfaceN.vertices=[];
SurfaceN.faces=[];
for N=1:length(Surfaces);
SurfaceN.vertices=Surfaces(N).Points;
SurfaceN.faces=Surfaces(N).ConnectivityList;
S=SurfaceN;trisurf(S.faces, S.vertices(:,1),S.vertices(:,2),S.vertices(:,3),'FaceAlpha', 0.5, 'FaceColor', 'r');
hold on
end
The 5 surfaces:
The 5 surfaces using trisurf with for loop
0 Comments
Accepted Answer
KSSV
on 27 Oct 2017
Edited: KSSV
on 2 Nov 2017
load surfaces.mat ;
coor = cell(5,1) ;
for N=1:length(Surfaces)
S.vertices=Surfaces(N).Points;
S.faces=Surfaces(N).ConnectivityList;
coor{N} = S.vertices ;
trisurf(S.faces, S.vertices(:,1),S.vertices(:,2),S.vertices(:,3),'FaceAlpha', 0.5, 'FaceColor', 'r');
hold on
end
coor = cell2mat(coor) ;
coor = unique(coor,'rows') ;
%
dt = delaunayTriangulation(coor(:,1),coor(:,2)) ;
x = dt.Points(:,1) ;
y = dt.Points(:,2) ;
%
idx = knnsearch(coor(:,1:2),[x,y]) ;
z = coor(idx,3) ;
tri = dt.ConnectivityList ;
figure
trisurf(tri,x,y,z)
4 Comments
More Answers (0)
See Also
Categories
Find more on Bounding Regions in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!