Simscape gas pipe element causes initialization errors
Show older comments
I have a Simscape model with a long thin (an inner diameter of 0.030") tube in the middle. When the tube is shorter (less than about 10 inches in length) the simulation runs perfectly, but when I change the tube to become longer (about 20 inches in length) I receive the following error message:
"Transient initialization, solving for consistent states and modes, failed to converge. Nonlinear solver: failed to converge, residual norm too large."
The actual tube is very long (multiple feet), so I don't know how to accurately model this in Simscape without getting error messages.
Accepted Answer
Ankitha Kollegal Arjun
on 25 Jul 2017
0 votes
It could be a modeling issue. Please use the troubleshooting steps mentioned in the following documentation to figure out any discrepancies in the model:
More Answers (0)
Categories
Find more on Gas Models in Help Center and File Exchange
on 20 Jul 2017
on 25 Jul 2017
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
