Why do I receive 'Data type mismatch' error when using a VCO in simulink?
1 view (last 30 days)
Show older comments
This is the error:
Data type mismatch. Input port 2 of '[FileName]/Frequency of single tone/Calculate single tone
frequency/Set to Zero if previous time was zero' expects a signal of data type
'double'. However, it is driven by a signal of data type 'boolean'.
Edit: Attached the simulink model.
0 Comments
Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!