Response optimization: Unable to get the optimization due to check custom bound error
2 views (last 30 days)
Show older comments
I created a simscape block for injector. I am interested to tune the parameter values of some input blocks values within the range known. I saved the parameters in 1 set as 'Design variable in optimisation windows session'. I created a check custom bound block in file - with the upper and lower bounds values: the upper is a profile(>0) and the lower bound as the 0 for upto 0.006s time. But when i try to run for optimization : I get the following error: Design Optimization 1 9:34:57 PM Aug 29, 2015 Elapsed: 0.342 sec
The requirements applied to 'Injector_optimiser/Check Custom Bounds' do not admit a feasible solution. The requirements 'Upper signal bound from '0.0000' to '0.0060' seconds.' and 'Lower signal bound from '0.0000' to '0.0060' seconds.' must not overlap.
Component: Design Optimization | Category: Optimize error
I am not well versed in optimization sequence or tools, I was following the tutorials in matlab sites - seeing suspension examples. I can share my file if needed, waiting for some advice to solve this issue.
regards,
sanjeet
Upper /lower bound
0 Comments
Answers (0)
See Also
Categories
Find more on Manual Performance Optimization in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!