MATLAB Answers

changing a parameter inside a continuous transfer function during simulation

5 views (last 30 days)
Danilo NASCIMENTO on 16 Aug 2015
Commented: Sebastian Castro on 17 Aug 2015
Hey guys, I want to change a parameter of a continuous transfer function during a simulation. Is that possible?

Answers (1)

Sebastian Castro
Sebastian Castro on 17 Aug 2015
Yes, it is possible.
You can go right into the block and change the parameters mid-simulation. When you hit "OK" in the block, the parameters update.
If you want to do this programmatically, you can do the following -- suppose you are changing a parameter K in a model called myModel:
>> K = 0.2;
>> set_param('myModel','SimulationCommand','update');
- Sebastian
Sebastian Castro
Sebastian Castro on 17 Aug 2015
I just tried this out by putting the above MATLAB commands inside a MATLAB Function block. Notice a few subtle changes like declaring some functions extrinsic (due to code generation), and also assigning values in the MATLAB base workspace with assignin (a necessary "evil" in this case).
This is then placed inside a Triggered Subsystem that triggers when the simulation time exceeds a certain value. For example:
Notice that I am changing the frequency w0 from 1 to 5 at a time of 4 seconds. My results change as follows:
- Sebastian

Sign in to comment.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!