repeating a simulink program

Hello,

Please i have the following code,

Answer 1

[Pratyush]

Hi Youness,

I understand that you want to repeat your code execution for 2hrs. The While Iterator block could be used for this purpose. You can refer to this documentation for more details on While Iterator block: https://in.mathworks.com/help/simulink/slref/whileiterator.html

To achieve this:

1. Add a "While Iterator" block from the Simulink Library Browser. This block will create a loop that repeats your code until a certain condition is met.
2. Connect the output of your code (the signal that controls the motor rotation) to the input of the "While Iterator" block.
3. Add a "Relational Operator" block from the Simulink Library Browser. Set the input of the "Relational Operator" block to the desired condition for stopping the loop.
4. Add a "Constant" block from the Simulink Library Browser and set its value to "true". Connect this block to the "Start" input of the "While Iterator" block. This will ensure that the loop starts when the simulation begins.

Hope this helps.

[Youness Tazi]

Thank you Pratyush, please i follow what you explain but i don't if that is correct or nor and i don't what i should connect on IC port and second input port for relational operator(because i have two input on my block idk which one to use with second relationnal block) could you help me with that please. attached picture.

Normally if you see on my block input there is 25mm and 0.5mm. those value is min and max (the value is from a potentiometer to change rotation of the motor, the initial state is when the position is at 0.5mm

Regards

Answer 2

[Youness Tazi]

;)