Use SPI Register Write in Simulink with STM32

How to use the SPI Register Write Block?

I like to control a Step motor in Simulink, where i have to configure the spi registers. For me it isn't visible how the Block parameters are set. I have already read the description of the Block "SPI Register Wrtie" from Matlab, but it didn't help at all.

I use STM32F401RE and the X-Nucleo-Board with the L6474 controller on top.

Answer 1

[Adit Kirtani]

Hi Sabrina,

To access the parameters to control the SPI Register Write block, be sure to double click on the block after adding it to your model. During run-time, these parameters will be used to control where the data goes and in what sequence. Here’s a link to the documentation page for the SPI Register Write Block:

https://www.mathworks.com/help/supportpkg/stmicroelectronicsstm32f4discovery/ref/spiregisterwrite.html

I hope this has answered your question.

Thank you,

Adit Kirtani.