add ylim and xlim only in the magnitude response of bode plot?
68 views (last 30 days)
Show older comments
hi guys,
How to add the ylim and xlim to the bode plot, magnitude only?
I havre added the ylim and xlim but the lines shows up in the phase plot and not the magnitude plot!
Cheers
0 Comments
Answers (1)
Robert U
on 22 Nov 2022
Hi SimTec,
If you are using bodeplot, you can have a look at bodeoptions()-command. There you can set the axis limits.
Kind regards,
Robert
2 Comments
Ben
on 25 Mar 2024
I have this issue as well. XLim is fine, I want them to be the same for both the magnitude and phase plots, but the YLIM applies the same limits to the phase and magnitude plots! There does not seem to be in bodeoptions a way to distinguish between the two plots.
Ben
on 25 Mar 2024
So the answer is simple... you add them in a cell like so:
opts.YLim = {[-20 10],[-50 150]}
See Also
Categories
Find more on Get Started with Control System Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!