how do i make this pv model work

I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.

[Joe Jones]

I have the same error. Can you tell me the solution to this error?Thank you very much.

Answer 1

[A Jenkins]

Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?

Answer 2

[anbumani p]

The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.

[SHASHWTEE Deb]

How to resolve this problem?

Answer 3

[Xing]

I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.