saving simulation results as .bmp
6 views (last 30 days)
Show older comments
I run a simulation from a mfile. there are some scopes in the simulink model and I would like to save these scopes as .bmp. i use saveas(gcf..) command. but at the end it saves another thing.
scopes_currentsDQ
saveas(gcf, ['.\caps\CurrentDQ\', ['CurrentDQ @ Speed=' num2str(SpeedCounter) 'RMS & Torque =' num2str(Torque_Demand) 'Nm'], '.bmp']);
itt does not save the currentsDQ results but a graph of a lookup table which is created before.
0 Comments
Answers (1)
Titus Edelhofer
on 12 Sep 2014
Hi,
if you have only one scope in your model, it's possible by
hFig = findall(0,'tag','SIMULINK_SIMSCOPE_FIGURE')
saveas(hFig, ...)
Note, that findall used this way finds all scopes ...
Titus
2 Comments
Image Analyst
on 12 Sep 2014
Mehmet's "Answer" moved here:
Hello, I have a lot of scopes. How can I refer a specific scope?
Image Analyst
on 12 Sep 2014
Try it and see. In that case hFig is probably a 1-D vector of handles. Refer to the one you want by its index.
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!