Send UDP message to remote interface with any data type and size
Arduino UDP Ethernet Shield
Send a UDP message to a remote interface identified by the remote IP address and remote port parameters.
Input can be any of the following supported int data types:
Input must be a 1-dimensional array. There is no limit to the length of the array. The length is only limited by the performance of the hardware.
Set the IP Address of the Remote Interface
Set the port of the Remote Interface
Set the local port on the Arduino
Set the data type of the input data
Set the data size of the input data
This block is supported for code generation.
This block can not currently have more than one instance in a model.