How can I control a pneumatic robot with Arduino and Matlab?
2 views (last 30 days)
Show older comments
Hello,
I have a robot consisting of pneumatic muscles and valves. So far the programm runs on Arduino IDE. Is ist possible to implement it into Matlab and Simulink, to get a simulation and save the sensor values? And how?
0 Comments
Accepted Answer
Amrtanshu Raj
on 20 Apr 2021
Hi,
There is no direct way to control a pneumatic value or actuator directly from matlab. However you can build your logic using Simulink and then later deploy it directly from Simulink with the help of Arduino Support package in MATLAB and Simulink.
You can also get the sensor values using the same package. This documentation will give you a good idea.
Bonus - With your logic designed in Simulink you can also use Simscape Fluid to simulate your pneumatics.
0 Comments
More Answers (0)
See Also
Categories
Find more on General Applications in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!