Simscape Error ; The following Inductors are connected together
17 views (last 30 days)
Show older comments
Hello,
I have a Boost PFC which I am trying to convert to interleaved architecture when tried running the simulation getting the error
Thanks in Advance.
1 Comment
hamza hamid
on 24 Mar 2021
Please me your Simulation model I will check the problem. This my email:hamidamza@yahoo.fr I have Matlab 2016b
Accepted Answer
Joel Van Sickel
on 24 Mar 2021
You can place a large resistor between the two inductors and connect it to ground. Start with 1e6 ohms.
Regards,
Joel
3 Comments
Joel Van Sickel
on 25 Mar 2021
yes, that should be fine, but to see how much it is affecting your simulation, you can measure the current going through the resistor. If it is above 1-2% of your system current, you may want to make it larger. (the smaller the resistor, the more innacurate your model will be, but the faster it can simulate. The larger the resistor, the more accurate, but the slower the model might run).
More Answers (0)
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Simscape Electrical in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!