How to use the line configurations of IEEE 123 nodes test feeder for modeling in Simulink

I am modeling the IEEE 123 nodes test feeder under simulink. I need to use it as a bechmark for my future research work. I have a big difficulty to understand the line configuration data. The configuration given on the document look like this:

Configuration 1:

           Z (R +jX) in ohms per mile
 0.4576  1.0780   0.1560  0.5017   0.1535  0.3849
                  0.4666  1.0482   0.1580  0.4236
                                   0.4615  1.0651
          B in micro Siemens per mile
            5.6765   -1.8319   -0.6982
                      5.9809   -1.1645
                                5.3971

I have two problems from this point: How to interpret those information so that I can use them the right way on Simulink? Once on simulink, what is the right block to use for the line configurations? Any guidance will be very helpful. Thanks in advance.

Answer 1

[sara authafa]

download the ieee 13 node distribution feeder and you will learn a lot from it