How do you get Simulink Data Inspector to use the same configuration on multiple runs

I have 8 plots with the signals from one run assigned to them. When I do another run how do I automatically get it to assign the data to the same plots?

[Vaibhav Awale]

Hi,

You can stream the signals in your model to Simulink Data Inspector. The signals can then be plot by checking the corresponding check box for the signal.

Signals from multiple runs can also be plotted this way. Also signals from multiple runs can be compared using the 'Comparisons' tab in Simulink Data Inspector.

May I know which version of MATLAB are you using? I might be able to provide a more specific answer based on your MATLAB version.

Regards,

Vaibhav Awale