Is the counter here working properly?
1 view (last 30 days)
Show older comments
I am trying to simulate a system in Simulink as shown below. It's kindof like a sigma-delta modulator. The two switches act like comparators - when the error exceeds the upper limit, +d becomes 1, otherwise it remains 0; when the error exceeds the lower limit, -d becomes 1, otherwise it remains 0. Both counters are set to count up, when there's rising edge from +d/-d.
Now the system is not working as I expected, and I noticed some weired behaviour of the counter at the top: +d only has one rising edge but the counter starts to count even before the rising edge. Is the counter working properly, or I'm doing something wrong? I've also attached the simulink model if it helps.
3 Comments
madhan ravi
on 30 Nov 2023
Have a look at Triggered and Enabled subsystem, when you respond just post the output signal scope that you would like to achieve for the specified inputs.
Accepted Answer
More Answers (0)
See Also
Categories
Find more on Schedule Model Components in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!