# Accurate measurement of inverter and motor efficiency

30 views (last 30 days)
ALEXANDER on 17 Jan 2023
Commented: Joel Van Sickel on 28 Feb 2023
I am building a model of a 300V, 100A DC-3φ inverter connected to a permanant magnent motor and am having trouble measuring inverter and motor efficiency. To measure efficency I need to find power. I am measuring DC power at the battery, AC power at the inverter, and mechanical power at the motor - however, I am getting very different power measurements for each, where I would expect around 10% deviation.
DC power at the battery is measured with the "Power Sensor" block. AC power at the inverter is measured two ways: with the "Power Sensor (Three-Phase)" block, and with the formula Pac=3/2*((Iq*Vq)+(Id*Vd)) (which is what we use to measure AC power on the hardware). Mechanical power at the motor is measured with the "Ideal Torque Sensor" block to get torque, and the "Ideal Rotational Motion Sensor" to get speed, and power is then calculated with P=Torque*((60/(2*pi))*Speed)/9.554. All measurements should be in watts. This is the result:
Red line is measured with the formula, green line is measured with the sensor. Any idea on why I have such large differences in power measurement, and how I can make it more accurate?
##### 2 CommentsShow 1 older commentHide 1 older comment
ALEXANDER on 27 Feb 2023
@Joel Van Sickel Attached is my current model, based on the Three Phase PMSM Drive sample. I have improved accuracy somewhat, but it is still quite inaccurate (it should be that Pm < Pabc < Pdc at all times by conservation of energy, but it isn't).

Sulaymon Eshkabilov on 17 Feb 2023
One quick note is the equations and conversions. It looks like there is a "pi" magnitude problem in your calculations of power.

Joel Van Sickel on 28 Feb 2023
Edited: Joel Van Sickel on 28 Feb 2023
Thank you for the model. The good news is your model is simulating correctly, and your assumptions are correct. The problem is the sensor setup and the filtering. One issue is that your 3 phase power calculation is doing line voltage * phase current. It needs to be line voltage * line current. This can be configured in the sensor you have on the three phase line. Another issue is that the filter you have on the 3 phase power is a different time constant than the filter on the other 2 signals. The final issue is that the filters are defaulting to discrete time. For this system, that is enough quantization error to further make the 3phase measurements wrong. If you change their time step to 0, you should get a continuous time filter implementation. If you do these things, you will be comparing apples to apples and not have quantization effects from discrete filters. This will cause the DC power signal to be highest and the mechanical power to be lowest (I also set external torque to 0 just to make sure I was comparing apples to apples, but you should be able to put external torque back in the way you have the system set up.)
##### 2 CommentsShow 1 older commentHide 1 older comment
Joel Van Sickel on 28 Feb 2023
Sure thing, here it is!

### Categories

Find more on Specialized Power Systems in Help Center and File Exchange

### Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!