F280049C biss encoder, numbers of clock

Hi All,

I'm trying to use this example: " Read Position of BiSS-C Absolute Encoder - MATLAB & Simulink - MathWorks Italia", but for some reason it doesn't work 100% correct. When I receive the frames from the SPIB interface, the third one it seems to be stucked showing always the same bits. I tried to see the signals on a oscilloscope and I noticed that the clock pulses ( MA signal) are less than what I expected. Is possibile in some way to configure the number of clock pulses?

P.S: I have an absolute encoder (26 bit) made my Renishaw.

Thank You very much.

Best regards,

Marcello

[만수]

Hi, Marcello

Have you solved this problem?

In my experience, no clock comes out from PWM1A after running the example. I'm curious how I can use the CLB module with just a few settings. It seems that the FSM module must be used, but it was not used at all. Currently, I set up and ran the F28386D module as in the example. Is this code related to the code generated from sysconfig?