Why do I get an error regarding "isfi" when using the "qammod" function?
5 views (last 30 days)
Show older comments
MathWorks Support Team
on 31 May 2022
Answered: MathWorks Support Team
on 14 Sep 2022
I am trying to use the "qammod" function from the Communications Toolbox and I am unable to use it as I receive an error. The command I am executing is shown below:
>> qammod(randi(1, 1, 10)-1, 2)
I receive the following error:
'isfi' requires Fixed-Point Designer.
Error in qammod>validateInput (line 257)
if isfi(x)
Error in qammod (line 95)
validateInput(x, M, bitInput, outputDataType);
Why can I not use "qammod"?
Accepted Answer
MathWorks Support Team
on 31 May 2022
The Communications Toolbox requires both the DSP System Toolbox and Signal Processing Toolbox to be installed, as well as MATLAB. The function "isfi" is shipped with the DSP System Toolbox which needs to be installed for the correct functioning of the "qammod" function. As the "qammod" function calls the "isfi" function, if the DSP System Toolbox is not installed then "qammod" will produce this error message.
To resolve this issue please reinstall the Communications Toolbox along with the previously stated required system products for the Communications Toolbox. This should resolve the issue.
I have attached a link to the Product Requirements for the Communications Toolbox below:
0 Comments
More Answers (0)
See Also
Categories
Find more on PHY Components in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!