Setup and Configuration

Install the hardware support for Xilinx^® Zynq^® Platform

The embedded target for Xilinx Zynq Platform enables you to:

Build a Simulink^® model that loads and runs an executable on the ARM^® Cortex^®-A processor embedded in the Xilinx Zynq Platform.
Use the capabilities and features described in Supported Features for Xilinx Zynq Platform.

To get this embedded target, perform the steps described in Install Support for Xilinx Zynq Platform.

Functions

zynq Display most recent IP address, user name, and password

Build, deploy, and run models on connected hardware boards

Supported Features for Xilinx Zynq Platform
List of supported features for Xilinx Zynq Platform.
Install Support for Xilinx Zynq Platform
Instructions to install support for Xilinx Zynq platform.
TFTP/WFTPD Configuration Guide
Set up and configure Trivial File Transfer Protocol (TFTP) or Winsock File Transfer Protocol Daemon (WFTPD) to use with your hardware board.
Hardware Setup Verification
Description of how the Embedded Coder^® Support Package for Xilinx Zynq Platform verifies the setup of the Xilinx Zynq hardware board.

To check if the Xilinx Zynq platform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.

Configure a Network Interface Card (NIC) on development computer to connect to hardware board.

You can get the IP address of the Xilinx Zynq platform from the MATLAB^® Command Window or using the Linux^® command line.

Open a serial command-line session with Xilinx Zynq platform.

Process to PING an Xilinx Zynq platform connected to your development computer.

Generate code from a Simulink® model and run the executable on a Xilinx® Zynq® platform.

Generate and run code from a Simulink® model onto a Xilinx® Zynq® ZC702 evaluation kit with a VxWorks® 7 operating system.