ADC Common
Use the ADC Common options to set the common ADC parameters.
ADC Prescaler
The option to select the frequency of the clock, PCLK2, to ADC. PCLK2 is derived
from system core clock and can have a maximum frequency of the clock as 84 MHz. When
you select the clock core to ADC, the default value of frequency for ADC is set to
48 MHz (PCLK2 divided by 2
)
Settings
Default:
PCLK2 divided by 2
Delay between two sampling phases
The option to select the minimum delay that separates two ADC conversions in interleaved mode.
Settings
Default:
5 * T_ADCCLK
Enable temperature sensor and V_Refint channel
The option to enable the temperature sensor and the V_Refint channel.
Settings
Default:
off
Enable V_BAT channel
The option to enable the V_BAT channel.
Settings
Default:
off
ADC modules synchronization
The option that you select for ADC module synchronization. The different options you available are:
Single mode: All ADCs are independent
— Select this option when the three ADCs must perform the conversion independently.Dual mode: ADC1 and ADC2 combined, ADC3 independent
— Select this option when you want to combine ADC1 and ADC2 and ADC3 to perform conversion independently.Triple mode: ADC1, ADC2, and ADC3 combined
— Select this option when you want to combine the ADC1, ADC2, and ADC3 together for conversion.
Settings
Default:
Single mode: All ADCs are independent
Multi ADC mode selection
The option that you select for multi-ADC mode.
Settings
Default:
Regular simultaneous and injected simultaneous
See Also
Model Configuration Parameters for STMicroelectronics STM32F4-Discovery Board | Model Configuration Parameters for STMicroelectronics STM32F746G-Discovery Board | Model Configuration Parameters for STMicroelectronics STM32F769I-Discovery Board