Install support Raspberry Pi™ hardware.
Connect Raspberry Pi Zero W to your computer using a USB cable.
Configure the board to send you an email message whenever the IP address changes
There are several ways to get the network settings of the Ethernet connector on your Raspberry Pi hardware:
Open a serial command-line session with Raspberry Pi hardware
Get or set IP address of Raspberry Pi hardware
Set up Raspberry Pi hardware as a Linux® desktop or teminal.
Extend the Linux partition on the SD card for Raspbian Linux image
Run Simulink® models on Raspberry Pi without providing a password.
Shut Down the Raspberry Pi Hardware
Troubleshoot Connecting to Raspberry Pi Hardware (MATLAB Support Package for Raspberry Pi Hardware)
Troubleshoot connecting to Raspberry Pi hardware.
Enable I2S drivers to output high-quality audio from Raspberry Pi using DAC.
When a Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.