enableI2C

Enable I2C interface

Description

example

enableI2C(bbb, bus_number) enables the indicated I2C bus and configures the GPIO pins for use as I2C pins. After you start the hardware, the i2c-1 bus is enabled by default.

Examples

collapse all

You can connect and exchange data with an I2C device on I2C bus 1.

Create a connection from the MATLAB® software to the BeagleBone® Black hardware.

bbb = beaglebone
bbb = 

  beaglebone with properties:

           DeviceAddress: '192.168.7.2'
               BoardName: 'BeagleBone Black Rev 00C0'
           AvailableLEDs: {'USR0'  'USR1'  'USR2'  'USR3'}
    AvailableDigitalPins: {1x29 cell}
     AvailableAnalogPins: {'AIN0'  'AIN1'  'AIN2'  'AIN3'  'AIN4'  'AIN5'  'AIN6'}
        AvailablePWMPins: {}
    AvailableSPIChannels: {}
       AvailableI2CBuses: {'i2c-1'}
    AvailableSerialPorts: {}
        AvailableWebcams: {} 

Enable I2C bus 1.

enableI2C(bbb,1)

Display AvailableI2CBuses.

bbb.AvailableI2CBuses
ans = 

    'i2c-1'    'i2c-2'

AvailableI2CBuses displays default bus 2 as i2c-1. The 1 is an internal index number. When you enable bus 1, AvailableI2CBuses displays it as i2c-2.

After physically connecting your I2C device to the I2C bus 1 pins, get the addresses of two I2C devices attached to I2C bus 1.

scanI2CBus(bbb,'i2c-2')
ans = 

     {'0x55','0x20'}

Create a connection, i2csensor, from the MATLAB software to the I2C sensor at '0x20'.

i2csensor = i2cdev(bbb,'i2c-2','0x20')
i2csensor = 

I2C with Properties:
     Bus: i2c-2
    I2CAddress: 0x20
       TimeOut: 10

Read two uint8 numbers from the sensor.

output1 = read(i2csensor,2);

Read the value of register 14 from the sensor.

output2 = readRegister(i2csensor,14);

Create a connection, i2cdisplay, from the MATLAB software to an I2C LED display at '0x55'.

i2cdisplay = i2cdev(bbb,'i2c-2','0x55')
i2cdisplay = 

I2C with Properties:
     Bus: i2c-2
    I2CAddress: 0x55
       TimeOut: 10

Write characters to the display.

write(i2cdisplay,[hex2dec('20') hex2dec('51')])

Write a scalar hexadecimal value, hex2dec('08'), to register 3 on an I2C device. uint8 is the default data type.

writeRegister(i2cdisplay,3,hex2dec('08'))

Input Arguments

collapse all

BeagleBone Black connection created using beaglebone, specified as an object.

The bus number identifies the I2C bus being enabled. By default, bus 2 is always enabled.

AvailableI2CBuses displays default bus 2 as i2c-1. The 1 is an index number. When you enable bus 1, AvailableI2CBuses displays it as i2c-2.

I2C bus 1 shares pins with SPI bus 0.

Example: 1

Introduced in R2015a