Simulate Model in Real-Time Normal Mode

You can use Simulink® normal mode to run a real-time simulation. This procedure uses the model sldrtex_model (matlab: open_system(docpath(fullfile(docroot, 'toolbox', 'sldrt', 'examples', 'sldrtex_model')))). It assumes that you have loaded that model.

  1. In the Simulink Editor, double-click the Scope block.

    The Simulink software opens a Scope window with an empty graph.

  2. On the Simulation tab, select Prepare > Normal simulation mode.

  3. Open the block parameters of the Real-Time Sync block in your Simulink Desktop Real-Time™ model.

  4. To prevent missed ticks, set values for the Sample Time and Maximum Missed Ticks block parameters.

  5. To begin simulation, on the Simulation tab, click Run.

    The Simulink software runs the simulation and plots the signal data in the Scope window.

  6. To stop the simulation before it ends, on the Simulation tab, click Stop.

    The real-time application stops running, and the Scope window stops displaying the output signals.

Related Topics