Program Control Flow of Motor Control Blockset Examples
This section describes the control flow of the field-oriented control (FOC) algorithm that the Motor Control Blockset™ examples use. The control flow operates using the hardware events along with the triggered software and hardware interrupts. This figure describes the interactions between the hardware modules and software subsystems.
The FOC based examples generally use the data speed of
the Current Control triggered software subsystem. Similarly, the
examples use the data speed of
2KHz for the Speed
Control triggered software subsystem. The ADC end of conversion (EOC)
interrupt (a hardware interrupt) triggers the current control subsystem. The PWM-ADC
synchronization controls the rate of this trigger. Similarly, a software interrupt
triggers the speed control subsystem.
The entire system uses external inputs for motor position, motor speed, motor currents, and the desired motor speed. The preceding figure shows the interactions between these data points and the enclosed subsystems.
Motor Control Blockset provides the Algorithm-Export Workflows for Custom Hardware example that includes Simulink® models for current control and speed control systems. The example provides instructions to generate code for these models. To create a FOC algorithm that can run on any motor control hardware, integrate this generated code with the hardware peripheral code (either auto-generated or manually written). Ensure that you activate the Current Control and Speed Control systems at appropriate times for the prescribed time intervals as shown in the preceding figure.
The following figure shows the entire structure of the integrated code.
The interaction between the PWM and ADC modules controls the rate of triggering of the Current Control subsystem. To reduce harmonics in the system, the PWM counter runs in center-aligned or up-down mode. We configure the PWM such that when PWM counter reaches the PWM counter period value, it triggers the ADC start of conversion (SOC) event. This ensures that the currents available at the ADC inputs are updated currents, and therefore, helps to measure the ADC currents correctly. Usually when you use shunt current sensors to measure the motor currents, the current-sense resistor is located on the lower legs of the inverter. Therefore, triggering the ADC SOC in the middle of the PWM period ensures that settled current values (No switching transients) are measured. This figure shows this interaction.
Motor Speed and Position Measurement
The FOC algorithm needs current position and speed of the motor. Usually either the position sensors or the sensorless estimation techniques help determine these values. The choice of the position sensing method depends on the factors such as cost, available space, required accuracy, and the motor control application itself. Motor Control Blockset supports these position sensing methods.
Quadrature encoder sensor
Sensorless position estimation techniques:
Sliding mode observer
Motor Control Blockset FOC examples use serial communication protocols for providing commands to the motor and reading debugging-related information from the motor control hardware. For details about this protocol, see Fast Serial Data Monitoring.