Use the Modbus Explorer App

You can read and write to coils and registers in the Modbus Explorer app. The app supports a subset of the MATLAB Modbus functionality. You can do the following in the Modbus Explorer:

  • Read coils, inputs, registers, and holding registers. This is the functionality of the Modbus read function.

  • Write to coils and holding registers. This is the functionality of the Modbus write function.

The app does not support the functionality of the Modbus writeRead function or the maskWrite function.

The Modbus Explorer offers a user interface to easily set up reads and writes and a live plot to see the values. The read table allows you to easily organize and manage reads for multiple addresses, such as different sensors on a PLC.

To launch the Modbus Explorer, do one of these:

  • In the MATLAB Apps tab, under Test & Measurement, select Modbus Explorer.

  • At the MATLAB command line, type modbusExplorer.

To use the Modbus Explorer, you need to configure your device and connect over TCP/IP or Serial RTU. For information about how to configure and connect to your device, see Configure a Connection in the Modbus Explorer.

After you have successfully configured your device in the Configure tab, press the Confirm Parameters button to open the read and write section of the Modbus Explorer. You can then perform reads and writes. For information about doing reads, see Read Coils, Inputs, and Registers in the Modbus Explorer. For information about doing writes, see Write to Coils and Holding Registers in the Modbus Explorer.

Related Topics