Hardware Support

USRP® E310 Support from Communications System Toolbox

Prototype and test software-defined radio (SDR) systems using USRP® E310 with MATLAB and Simulink


Capabilities and Features

Communications System Toolbox™ Support Package for USRP® Embedded Series Radio enables you to use MATLAB® and Simulink® to prototype, verify, and test practical wireless systems. Using this support package with a USRP® E310 SDR, you can work with live RF signals using dual (2x2) transmit and receive streams. You can also implement custom hardware designs for your SDR applications using HDL Coder™ or Embedded Coder®. This enables you to test your design under real-world conditions and rapidly prototype designs for mobile and embedded applications.

Support highlights include the ability to:

  • Stream 2x2 channel RF signals into and out of MATLAB and Simulink
  • Enhance transmit and receive selectivity using automatic selection of RF front end filter banks
  • Acquire and transmit high bandwidth signals using burst mode
  • Implement custom algorithms on the FPGA fabric and ARM processor using HDL coder or Embedded Coder (Note: Xilinx Vivado® Design Suite is required. Refer to "Required Third-Party Tools” in the documentation.)

Learn about support for other USRP® devices (B, X, and N series).

Platform and Release Support

See the hardware support package system requirements table for current and prior version, release, and platform availability.

View enhancements and bug fixes in release notes.


Related Hardware Support Views: Communications System Toolbox, C ∕ C++ Code Generation, Ettus Research, HDL Code Generation, MathWorks Supported, MATLAB Product Family, National Instruments, Simulink Product Family, Support Package Installer Enabled, Wireless Communications

Ready to install?

Before installing the support package, confirm you have the correct setup. View system requirements and installation options.

Get Support Package

Software

Required

Recommended

Support Package

Required

Support Package Installer installs this support package and all required third-party software. To start the installer, go to the MATLAB tool strip and click Add-Ons > Get Hardware Support Packages. For more information, read the documentation.
 
Get Support Package

Hardware

Required

Software

Required

All required third-party software is installed by the Support Package Installer.

For more information about using Xilinx tools with HDL Coder and Embedded Coder for ARM and FPGA fabric customization, see the Third Party Software Support section in the product documentation.

Don't see the hardware you're looking for?